Easy Vacuum Repairs: Replacing a Vacuum Belt
Read this tip to make your life smarter, better, faster and wiser. LifeTips is the place to go when you need to know about Vacuum Repair and other Vacuum topics.
What are the steps for replacing a vacuum belt?
Replacing the belt is an easy vacuum repair task that only takes a few moments.
- Unplug the vacuum.
- Remove the bottom cover.
- Pull out the roller brush and remove the other end of the belt from the motor drive shaft.
- Discard the old belt, slide the new one onto the roller brush and then back onto the motor drive shaft.
- Replace the bottom cover.
Comments
4/8/2009 11:23:22 PM
Derek
said:
what about if the vacuum doesnt suck up anymore?